Aruba A été utilisé un Aruba S2500-24p-4x10g Hard Reset Au niveau de l'écran LCD Allez dans le menu Maintenance et sélectionnez "Factory Default" Effectuer via le menu le reboot du switch   Information de login par défaut admin/admin123 Perte du mot passe admin En console Utilisateur: mot de passe Mot de passe: forgetme! (Aruba) > activer Mot de passe: activer (Aruba) #configure terminal entrez les commandes de configuration, une par ligne. Fin avec CNTL/Z Aruba) (config) #mgmt-User Admin mot de passe root: < new admin password > Re-tapez mot de passe: < new admin password > (Aruba) (config) #exit (Aruba) #exit (Aruba) > Exit   Utilisateur: admin Mot de passe: < new admin password > (Aruba) > activer Mot de passe: activer (Aruba) #configure terminal entrez les commandes de configuration, une par ligne. Fin avec CNTL/Z (Aruba) (config) #enable secret Mot de passe: < new enable password > Re-tapez mot de passe: < new enable password > (Aruba) (config) #write mémoire Initialisation & configuration basique Notes pré installation : Les câbles console de chez Cisco fonctionne très bien. Baud Rate Data Bits Parity Stop Bits Flow Control 9600 8 None 1 Off Configuration via GUI quick config La mise en page sous IE est étrange, mais l'important est de pouvoir la valider la configuration basique. Casser le staking présent par défaut (ArubaS2500-24P) (config) #show interface brief Interface Admin Link Line Protocol Speed/Duplex --------- ----- ---- ------------- ------------ GE0/0/0 Enable Up Up 1 Gbps / Full GE0/0/1 Enable Down Down N/A GE0/0/2 Enable Up Up 100 Mbps / Full GE0/0/3 Enable Down Down N/A GE0/0/4 Enable Up Up 100 Mbps / Full GE0/0/5 Enable Down Down N/A GE0/0/6 Enable Up Up 100 Mbps / Full GE0/0/7 Enable Down Down N/A GE0/0/8 Enable Up Up 100 Mbps / Full GE0/0/9 Enable Down Down N/A GE0/0/10 Enable Down Down N/A GE0/0/11 Enable Down Down N/A GE0/0/12 Enable Down Down N/A GE0/0/13 Enable Down Down N/A GE0/0/14 Enable Down Down N/A GE0/0/15 Enable Down Down N/A GE0/0/16 Enable Down Down N/A GE0/0/17 Enable Down Down N/A GE0/0/18 Enable Down Down N/A GE0/0/19 Enable Down Down N/A GE0/0/20 Enable Down Down N/A GE0/0/21 Enable Down Down N/A GE0/0/22 Enable Down Down N/A GE0/0/23 Enable Down Down N/A GE0/1/0 Enable Down Down N/A GE0/1/1 Enable Down Down N/A MGMT Enable Down Down N/A (ArubaS2500-24P) (config) # show stacking interface stack1/2 -------- stack1/2 is administratively Enabled, link is Down, line protocol is Down Speed: N/A, MTU: 9224 bytes, Link flaps: 0 Last update of counters: 0d 00:00:00 ago Last clearing of counters: 0d 00:00:00 ago Link status last changed: 0d 00:00:00 ago Statistics: Received 0 frames, 0 octets 0 pps, 0 bps 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 error octets, 0 CRC frames 0 multicast, 0 unicast Transmitted 0 frames, 0 octets 0 pps, 0 bps 0 broadcasts, 0 throttles 0 multicast, 0 unicast 0 errors octets, 0 deferred 0 collisions, 0 late collisions stack1/3 -------- stack1/3 is administratively Enabled, link is Down, line protocol is Down Speed: N/A, MTU: 9224 bytes, Link flaps: 0 Last update of counters: 0d 00:00:00 ago Last clearing of counters: 0d 00:00:00 ago Link status last changed: 0d 08:13:09 ago Statistics: Received 0 frames, 0 octets 0 pps, 0 bps 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 error octets, 0 CRC frames 0 multicast, 0 unicast Transmitted 0 frames, 0 octets 0 pps, 0 bps 0 broadcasts, 0 throttles 0 multicast, 0 unicast 0 errors octets, 0 deferred 0 collisions, 0 late collisions (ArubaS2500-24P) (config) # delete stacking interface stack 1/2 (ArubaS2500-24P) (config) # delete stacking interface stack 1/3 (ArubaS2500-24P) (config) #show interface brief Interface Admin Link Line Protocol Speed/Duplex --------- ----- ---- ------------- ------------ GE0/0/0 Enable Up Up 1 Gbps / Full GE0/0/1 Enable Down Down N/A GE0/0/2 Enable Up Up 100 Mbps / Full GE0/0/3 Enable Down Down N/A GE0/0/4 Enable Up Up 100 Mbps / Full GE0/0/5 Enable Down Down N/A GE0/0/6 Enable Up Up 100 Mbps / Full GE0/0/7 Enable Down Down N/A GE0/0/8 Enable Up Up 100 Mbps / Full GE0/0/9 Enable Down Down N/A GE0/0/10 Enable Down Down N/A GE0/0/11 Enable Down Down N/A GE0/0/12 Enable Down Down N/A GE0/0/13 Enable Down Down N/A GE0/0/14 Enable Down Down N/A GE0/0/15 Enable Down Down N/A GE0/0/16 Enable Down Down N/A GE0/0/17 Enable Down Down N/A GE0/0/18 Enable Down Down N/A GE0/0/19 Enable Down Down N/A GE0/0/20 Enable Down Down N/A GE0/0/21 Enable Down Down N/A GE0/0/22 Enable Down Down N/A GE0/0/23 Enable Down Down N/A GE0/1/0 Enable Down Down N/A GE0/1/1 Enable Down Down N/A GE0/1/2 Enable Down Down N/A GE0/1/3 Enable Down Down N/A MGMT Enable Down Down N/A Ajout d'un utilisateur (ArubaS2500-24P) (config) #mgmt-user ? Name of the user (maximum 16 characters). localauth-disable Disable Local authentication event if RADIUS authentication timeout. password-recovery-dis.. Disable recovery login ssh-pubkey SSH login of management users by public key authentication webui-cacert CA Certificate used to sign management user's certificate (ArubaS2500-24P) (config) #mgmt-user nida ? Role name from one of the following: root - super user role guest-provisioning - guest provisioning role network-operations - Network operator role read-only - Read only role location-api-mgmt - Location API Management Role (ArubaS2500-24P) (config) #mgmt-user nida root Password:*********** Re-Type password:********** (ArubaS2500-24P) (config) #show mgmt-user Management User Table --------------------- USER PASSWD ROLE STATUS ---- ------ ---- ------ admin ***** root ACTIVE nida ***** root ACTIVE Jumbo Frames (ArubaS2500-24P) (config) #show interface gigabitethernet 0/0/0 GE0/0/0 is administratively Up, Link is Up, Line protocol is Upq Hardware is Gigabit Ethernet, Interface is GE0/0/0, Address is 00:0b:86:aa:a6:c2 Encapsulation ARPA, Loopback not set Configured: duplex (Auto), Speed (Auto), FC (Off), Autoneg (On) Negotiated: duplex (Full), Speed (1 Gbps) Interface index: 1 MTU 1514 bytes (ArubaS2500-24P) (config) #interface gigabitethernet 0/0/0 (ArubaS2500-24P) (gigabitethernet "0/0/0") #mtu ? Set MTU on interface between 64 and 9216 (ArubaS2500-24P) (gigabitethernet "0/0/0") #mtu 9216 (ArubaS2500-24P) (config) #show interface gigabitethernet 0/0/0 GE0/0/0 is administratively Up, Link is Up, Line protocol is Up Hardware is Gigabit Ethernet, Interface is GE0/0/0, Address is 00:0b:86:aa:a6:c2 Encapsulation ARPA, Loopback not set Configured: duplex (Auto), Speed (Auto), FC (Off), Autoneg (On) Negotiated: duplex (Full), Speed (1 Gbps) Interface index: 1 MTU 9216 bytes   Configuration SNMP v2 (ArubaS2500-24P) (config) #show snmp community SNMP COMMUNITIES ---------------- COMMUNITY ACCESS VERSION --------- ------ ------- Zer0t0uchpr0visi0ning READ_ONLY V1, V2C (ArubaS2500-24P) (config) #hostname ArubaS2500-24P (ArubaS2500-24P) (config) #syscontact monitoring (ArubaS2500-24P) (config) #syslocation France (ArubaS2500-24P) (config) #snmp-server community public (ArubaS2500-24P) (config) #snmp-server enable trap (ArubaS2500-24P) (config) #snmp-server host 192.168.1.205 community public (ArubaS2500-24P) (config) #snmp-server engine-id ?       Engine ID of SNMP server in HEX (10-64 chars) eg.                          800039e703000b86112233 (ArubaS2500-24P) (config) #snmp-server engine-id 800039e703000b86112233 Configuration SNMP v3     vLAN & DHCP Création d'un vLan (ArubaS2500-24P) (VLAN "4") #vlan 10 (ArubaS2500-24P) (VLAN "10") #description lab (ArubaS2500-24P) (VLAN "10") #exit Attribution d'une IP (ArubaS2500-24P) (vlan "10") #ip address 172.16.255.250 255.255.0.0 (ArubaS2500-24P) (vlan "10") #mtu 1500 (ArubaS2500-24P) (vlan "10") #exit Configuration du switching-profile pour le vLAN (ArubaS2500-24P) (config) #interface-profile switching-profile vlan10-sw (ArubaS2500-24P) (switching profile "vlan10-sw") #switchport-mode access (ArubaS2500-24P) (switching profile "vlan10-sw") #access-vlan 10 (ArubaS2500-24P) (switching profile "vlan10-sw") #native-vlan 10 (ArubaS2500-24P) (switching profile "vlan10-sw") #exit Application du vLAN à un port (ArubaS2500-24P) (config) #interface gigabitethernet 0/0/0 (ArubaS2500-24P) (gigabitethernet "0/0/8") #switching-profile vlan10-sw (ArubaS2500-24P) (gigabitethernet "0/0/8") #exit Application du vLAN à un groupe de ports (ArubaS2500-24P) (config) #interface-group gigabitethernet vlan10-grp (ArubaS2500-24P) (gigabitethernet "vlan10") #apply-to 0/0/0-0/0/3 (ArubaS2500-24P) (gigabitethernet "vlan10") #trusted port (ArubaS2500-24P) (gigabitethernet "vlan10") #no shutdown (ArubaS2500-24P) (gigabitethernet "vlan10") #switching-profile vlan10 (ArubaS2500-24P) (gigabitethernet "vlan10") #exit (ArubaS2500-24P) (config) #exit (ArubaS2500-24P) #write memory Ajout ou suppression d'interface à un vLAN (ArubaS2500-24P) (gigabitethernet "vlan10") #apply-to [add | remove] DHCP (ArubaS2500-24P) (config) #ip dhcp pool vlan10-pool (ArubaS2500-24P) (dhcp server profile "vlan10-pool") # (ArubaS2500-24P) (dhcp server profile "vlan10-pool") #? clone                              Copy data from another dhcp server profile default-router                DHCP default router in A.B.C.D format dns-server                      DNS servers in A.B.C.D format domain-name                Specify domain name exclude-address            Configure exclude address hardware-address         MAC address of the device lease                              DHCP server pool lease time (Default: 12 hours) netbios-name-server     Configure netbios name servers in A.B.C.D format network                         DHCP server network pool no                                  Delete Command option                            Configure server option vendor-class-identifi..    Configure vendor-class-identifier (Default: ArubaAP)