Aruba
A été utilisé un Aruba S2500-24p-4x10g
Hard Reset
Au niveau de l'écran LCD
Information de login par défaut
admin/admin123
Perte du mot passe admin
En console
Utilisateur: mot de passe
Mot de passe: forgetme!
(Aruba) > activer
Mot de passe: activer
(Aruba) #configure terminal entrez les commandes de configuration, une par ligne. Fin avec CNTL/Z
Aruba) (config) #mgmt-User Admin mot de passe root: < new admin password >
Re-tapez mot de passe: < new admin password >
(Aruba) (config) #exit
(Aruba) #exit
(Aruba) > Exit
Utilisateur: admin
Mot de passe: < new admin password >
(Aruba) > activer
Mot de passe: activer
(Aruba) #configure terminal entrez les commandes de configuration, une par ligne. Fin avec CNTL/Z
(Aruba) (config) #enable secret
Mot de passe: < new enable password >
Re-tapez mot de passe: < new enable password >
(Aruba) (config) #write mémoire
Initialisation & configuration basique
Notes pré installation :
Les câbles console de chez Cisco fonctionne très bien.
Baud Rate | Data Bits | Parity | Stop Bits | Flow Control |
9600 | 8 | None | 1 | Off |
Configuration via GUI quick config
La mise en page sous IE est étrange, mais l'important est de pouvoir la valider la configuration basique.
Casser le staking présent par défaut
(ArubaS2500-24P) (config) #show interface brief
Interface Admin Link Line Protocol Speed/Duplex
--------- ----- ---- ------------- ------------
GE0/0/0 Enable Up Up 1 Gbps / Full
GE0/0/1 Enable Down Down N/A
GE0/0/2 Enable Up Up 100 Mbps / Full
GE0/0/3 Enable Down Down N/A
GE0/0/4 Enable Up Up 100 Mbps / Full
GE0/0/5 Enable Down Down N/A
GE0/0/6 Enable Up Up 100 Mbps / Full
GE0/0/7 Enable Down Down N/A
GE0/0/8 Enable Up Up 100 Mbps / Full
GE0/0/9 Enable Down Down N/A
GE0/0/10 Enable Down Down N/A
GE0/0/11 Enable Down Down N/A
GE0/0/12 Enable Down Down N/A
GE0/0/13 Enable Down Down N/A
GE0/0/14 Enable Down Down N/A
GE0/0/15 Enable Down Down N/A
GE0/0/16 Enable Down Down N/A
GE0/0/17 Enable Down Down N/A
GE0/0/18 Enable Down Down N/A
GE0/0/19 Enable Down Down N/A
GE0/0/20 Enable Down Down N/A
GE0/0/21 Enable Down Down N/A
GE0/0/22 Enable Down Down N/A
GE0/0/23 Enable Down Down N/A
GE0/1/0 Enable Down Down N/A
GE0/1/1 Enable Down Down N/A
MGMT Enable Down Down N/A(ArubaS2500-24P) (config) # show stacking interface
stack1/2
--------
stack1/2 is administratively Enabled, link is Down, line protocol is Down
Speed: N/A, MTU: 9224 bytes, Link flaps: 0
Last update of counters: 0d 00:00:00 ago
Last clearing of counters: 0d 00:00:00 ago
Link status last changed: 0d 00:00:00 ago
Statistics:
Received 0 frames, 0 octets
0 pps, 0 bps
0 broadcasts, 0 runts, 0 giants, 0 throttles
0 error octets, 0 CRC frames
0 multicast, 0 unicast
Transmitted 0 frames, 0 octets
0 pps, 0 bps
0 broadcasts, 0 throttles
0 multicast, 0 unicast
0 errors octets, 0 deferred
0 collisions, 0 late collisionsstack1/3
--------
stack1/3 is administratively Enabled, link is Down, line protocol is Down
Speed: N/A, MTU: 9224 bytes, Link flaps: 0
Last update of counters: 0d 00:00:00 ago
Last clearing of counters: 0d 00:00:00 ago
Link status last changed: 0d 08:13:09 ago
Statistics:
Received 0 frames, 0 octets
0 pps, 0 bps
0 broadcasts, 0 runts, 0 giants, 0 throttles
0 error octets, 0 CRC frames
0 multicast, 0 unicast
Transmitted 0 frames, 0 octets
0 pps, 0 bps
0 broadcasts, 0 throttles
0 multicast, 0 unicast
0 errors octets, 0 deferred
0 collisions, 0 late collisions(ArubaS2500-24P) (config) # delete stacking interface stack 1/2
(ArubaS2500-24P) (config) # delete stacking interface stack 1/3
(ArubaS2500-24P) (config) #show interface briefInterface Admin Link Line Protocol Speed/Duplex
--------- ----- ---- ------------- ------------
GE0/0/0 Enable Up Up 1 Gbps / Full
GE0/0/1 Enable Down Down N/A
GE0/0/2 Enable Up Up 100 Mbps / Full
GE0/0/3 Enable Down Down N/A
GE0/0/4 Enable Up Up 100 Mbps / Full
GE0/0/5 Enable Down Down N/A
GE0/0/6 Enable Up Up 100 Mbps / Full
GE0/0/7 Enable Down Down N/A
GE0/0/8 Enable Up Up 100 Mbps / Full
GE0/0/9 Enable Down Down N/A
GE0/0/10 Enable Down Down N/A
GE0/0/11 Enable Down Down N/A
GE0/0/12 Enable Down Down N/A
GE0/0/13 Enable Down Down N/A
GE0/0/14 Enable Down Down N/A
GE0/0/15 Enable Down Down N/A
GE0/0/16 Enable Down Down N/A
GE0/0/17 Enable Down Down N/A
GE0/0/18 Enable Down Down N/A
GE0/0/19 Enable Down Down N/A
GE0/0/20 Enable Down Down N/A
GE0/0/21 Enable Down Down N/A
GE0/0/22 Enable Down Down N/A
GE0/0/23 Enable Down Down N/A
GE0/1/0 Enable Down Down N/A
GE0/1/1 Enable Down Down N/A
GE0/1/2 Enable Down Down N/A
GE0/1/3 Enable Down Down N/A
MGMT Enable Down Down N/A
Ajout d'un utilisateur
(ArubaS2500-24P) (config) #mgmt-user ?
<username> Name of the user (maximum 16 characters).
localauth-disable Disable Local authentication event if RADIUS
authentication timeout.
password-recovery-dis.. Disable recovery login
ssh-pubkey SSH login of management users by public key
authentication
webui-cacert CA Certificate used to sign management user's
certificate(ArubaS2500-24P) (config) #mgmt-user nida ?
<rolename> Role name from one of the following:
root - super user role
guest-provisioning - guest provisioning role
network-operations - Network operator role
read-only - Read only role
location-api-mgmt - Location API Management Role(ArubaS2500-24P) (config) #mgmt-user nida root
Password:***********
Re-Type password:**********(ArubaS2500-24P) (config) #show mgmt-user
Management User Table
---------------------
USER PASSWD ROLE STATUS
---- ------ ---- ------
admin ***** root ACTIVE
nida ***** root ACTIVE
Jumbo Frames
(ArubaS2500-24P) (config) #show interface gigabitethernet 0/0/0
GE0/0/0 is administratively Up, Link is Up, Line protocol is Upq
Hardware is Gigabit Ethernet, Interface is GE0/0/0, Address is 00:0b:86:aa:a6:c2
Encapsulation ARPA, Loopback not set
Configured: duplex (Auto), Speed (Auto), FC (Off), Autoneg (On)
Negotiated: duplex (Full), Speed (1 Gbps)
Interface index: 1
MTU 1514 bytes(ArubaS2500-24P) (config) #interface gigabitethernet 0/0/0
(ArubaS2500-24P) (gigabitethernet "0/0/0") #mtu ?<mtu> Set MTU on interface between 64 and 9216
(ArubaS2500-24P) (gigabitethernet "0/0/0") #mtu 9216
(ArubaS2500-24P) (config) #show interface gigabitethernet 0/0/0
GE0/0/0 is administratively Up, Link is Up, Line protocol is Up
Hardware is Gigabit Ethernet, Interface is GE0/0/0, Address is 00:0b:86:aa:a6:c2
Encapsulation ARPA, Loopback not set
Configured: duplex (Auto), Speed (Auto), FC (Off), Autoneg (On)
Negotiated: duplex (Full), Speed (1 Gbps)
Interface index: 1
MTU 9216 bytes
Configuration SNMP v2
(ArubaS2500-24P) (config) #show snmp community
SNMP COMMUNITIES
----------------
COMMUNITY ACCESS VERSION
--------- ------ -------
Zer0t0uchpr0visi0ning READ_ONLY V1, V2C(ArubaS2500-24P) (config) #hostname ArubaS2500-24P
(ArubaS2500-24P) (config) #syscontact monitoring
(ArubaS2500-24P) (config) #syslocation France
(ArubaS2500-24P) (config) #snmp-server community public
(ArubaS2500-24P) (config) #snmp-server enable trap
(ArubaS2500-24P) (config) #snmp-server host 192.168.1.205 community public
(ArubaS2500-24P) (config) #snmp-server engine-id ?<engineid> Engine ID of SNMP server in HEX (10-64 chars) eg.
800039e703000b86112233(ArubaS2500-24P) (config) #snmp-server engine-id 800039e703000b86112233
Configuration SNMP v3
vLAN & DHCP
Création d'un vLan
(ArubaS2500-24P) (VLAN "4") #vlan 10
(ArubaS2500-24P) (VLAN "10") #description lab
(ArubaS2500-24P) (VLAN "10") #exit
Attribution d'une IP
(ArubaS2500-24P) (vlan "10") #ip address 172.16.255.250 255.255.0.0
(ArubaS2500-24P) (vlan "10") #mtu 1500
(ArubaS2500-24P) (vlan "10") #exit
Configuration du switching-profile pour le vLAN
(ArubaS2500-24P) (config) #interface-profile switching-profile vlan10-sw
(ArubaS2500-24P) (switching profile "vlan10-sw") #switchport-mode access
(ArubaS2500-24P) (switching profile "vlan10-sw") #access-vlan 10
(ArubaS2500-24P) (switching profile "vlan10-sw") #native-vlan 10
(ArubaS2500-24P) (switching profile "vlan10-sw") #exit
Application du vLAN à un port
(ArubaS2500-24P) (config) #interface gigabitethernet 0/0/0
(ArubaS2500-24P) (gigabitethernet "0/0/8") #switching-profile vlan10-sw
(ArubaS2500-24P) (gigabitethernet "0/0/8") #exit
Application du vLAN à un groupe de ports
(ArubaS2500-24P) (config) #interface-group gigabitethernet vlan10-grp
(ArubaS2500-24P) (gigabitethernet "vlan10") #apply-to 0/0/0-0/0/3
(ArubaS2500-24P) (gigabitethernet "vlan10") #trusted port
(ArubaS2500-24P) (gigabitethernet "vlan10") #no shutdown
(ArubaS2500-24P) (gigabitethernet "vlan10") #switching-profile vlan10
(ArubaS2500-24P) (gigabitethernet "vlan10") #exit
(ArubaS2500-24P) (config) #exit
(ArubaS2500-24P) #write memory
Ajout ou suppression d'interface à un vLAN
(ArubaS2500-24P) (gigabitethernet "vlan10") #apply-to [add | remove] <interface-list>
DHCP
(ArubaS2500-24P) (dhcp server profile "vlan10-pool") #
(ArubaS2500-24P) (dhcp server profile "vlan10-pool") #?
clone Copy data from another dhcp server profile
default-router DHCP default router in A.B.C.D format
dns-server DNS servers in A.B.C.D format
domain-name Specify domain name
exclude-address Configure exclude address
hardware-address MAC address of the device
lease DHCP server pool lease time (Default: 12 hours)
netbios-name-server Configure netbios name servers in A.B.C.D format
network DHCP server network pool
no Delete Command
option Configure server option
vendor-class-identifi.. Configure vendor-class-identifier (Default: ArubaAP)